When I went back to work on Tuesday, after the holiday weekend, surprisingly it was kind of slow, so left work at noon and took Wednesday off also. My cleaning effort had cleared off the table enough that the Plexiglas could be laid out and cut. My original idea was to bend the edges down so any water would roll off but after trying a hair dryer, then a propane torch, I did get it to bend but when it was test fitted, was too wide to fit.
BENDING THE PLEXIGLAS
On to plan B, just cut a flat Plexiglas cover, make a slot for the trans axle cables, cut 4 bolts to make studs for the coupling nuts, drill 4 holes, and bolt the cover over the battery.
PLEXIGLAS COVER INSTALLED
END VIEW
Thanks for stopping by,
Randy
No comments:
Post a Comment