Saturday, August 29, 2015

NATIONAL DRIVE ELECTRIC WEEK - COLUMBUS, OH

Recently I signed up to take the Fiero to National Drive Electric Week - Columbus, OH, to be held on September 12, 2015 at Easton Town Center.


National Drive Electric Week is presented by Plug In America Sierra Club Electric Auto Association
National Drive Electric Week Event - Columbus
Day:Saturday, September 12, 2015
Time:9:00 AM to 1:00 PM
Location:Easton Town Center
3945 Easton Square Pl
Columbus, OH 43219
 to attend this event.
 to help the organizers for this event.
 the organizers for this event.

Last week troubleshooting was done on the retractable headlight motors, and it was finally discovered that a fuse was blown and the positive connector on the main contactor was not fully seated. The connections were cleaned with alcohol and coated with Nolox, zinc connection compound.


LIGHTS STUCK IN OPEN POSITION


HEADLIGHT MOTOR SCHEMATIC


HEADLIGHT DOORS CLOSED

The body of the Fiero is a mess, with a bad repaint job dull and flaking off in areas but I took the car to Bowman Detail Shop in Hebron, Oh, and they feel they can make the car look better. An appointment was made to have the car detailed next Wednesday. The bottom of the bumpers and ground effects on the side of the car is going to be wet sanded and painted satin black and the driver side was painted this morning.


SIDE GROUND EFFECT PAINTED SATIN BLACK

Also, a couple of nicks in the front of the hood were painted gloss black. If I have time, I may try to put a little body putty in them and then paint them again.


NICKS IN HOOD

Still quite a bit of work to do to get the car in shape to take to the National Drive Electric Week event and EVCCON but hopefully everything will come together.

Randy

2 comments:

Australia said...

The left window switch of my car is not working. But I can do it from the right side( driver side switch)

my Question is should i Replace the switch or Please guide me what should i do? thank you

cztree said...

You may want to check the switch with an ohmmeter first and make sure that is the problem. It could be a bad connection on the connector causing the window not to operate.