Sunday, February 8, 2015

SUNDAY, PART II

After getting the gauges working this morning, attention was turned to putting the center console back in the car and hooking up the heater control. Extensions were plugged into the continuous 12 volt supply and pack voltage positive wires. A 12 volt switched supply was found, so connectors were added and extensions were run so it could be hooked into the JLD404.

The heater control was hooked up and after repairing the 12 volt positive line that comes off of the heater fan supply, it was tested.


HEATER CONTROLS IN HOT POSITION


SOLID STATE RELAY ENERGIZED

All and all a pretty good weekend of work and I can see light at the end of the tunnel in getting the interior back together.

Until next time,

Randy
Post a Comment