Sunday, April 5, 2015

INTERIOR FINISHING TOUCHES

After a 120 mile drove to and from my parents, a little more progress was made on the Fiero. An opening was cut in the laminated face plate that was made and it was painted black. After drying, the face plate was test fit and it is going to work out well.


JLD404 FACE PLATE

Then the fuses were checked to see if that is the cause of the dash lamps not working. All of the fuses were good so I checked the dimmer switch and sure enough, it was all the way on dim. After moving it to full illumination position, the right side lamps lit but not the left side. This means that the connector pulled out of the dash socket when the rear cover was put back on, so it will need to come off again.


RIGHT SIDE DASH LAMPS WORKING

All and all a pretty productive day but I will really be glad to get the interior wrapped up and be able to move on to getting the front batteries and new vacuum pump installed.

Until next time,

Randy
Post a Comment